The Last Check Before the Drill Moves: Seed, Depth and Moisture Together
On the morning the drill is due to move, a short pause saves a whole day of regret. Before the tractor leaves the yard, check three things together: the seed, the sowing depth you intend, and the moisture waiting in the field. Any one of them can be right on its own, yet the crop will still struggle if the other two are wrong.
Check the Seed in Your Hand
Open a bag in daylight and look closely. Good wheat seed is clean, bold and uniform, with no dust, no broken grains and no smell of damp storage. Take a handful from the top, middle and bottom of the bag, because problems often hide in one layer. If you did a wet cloth germination test, sow only when the result was strong. If seed looks mixed or shrivelled, do not hope the drill will sort it out. It will not.
Set Depth Before You Enter the Field
Decide the depth while you are still on firm ground. In most South Punjab soils in late October, wheat seed needs firm contact with moist soil, covered well but not buried so deep that the shoot wastes its strength reaching light. Check the drill setting on a hard patch first, then again after the first short run in the field, because loose soil lets coulters sink deeper than the setting suggests.
Read the Moisture, Not the Calendar
Push a spade in and squeeze soil from sowing depth. It should hold together lightly and feel cool and damp, without shining wet or crumbling to dust. If the top has dried but moisture sits just below, a shallow adjustment may place seed correctly. If the whole layer is dry, wait for rauni or irrigation rather than sowing into dust and praying for rain.
Walk the field once, note low patches where moisture lasts longer, and start where conditions are most even. Ten minutes spent on seed, depth and moisture together is the cheapest insurance of the sowing season.

Comments
Post a Comment